GRAPHTEC FC8600-60 Service Manual page 108

Error
Error Display
code
E01018
E01019
FC8600-UM-251-9370
Cause
Cutting conditions do Cutting conditions.
not suit the cutting
medium.
Movement of the Is there anything
pen carriage is being blocking the Y slider?
obstructed.
Excessive load is (1) Does the Y
causing the current to
the motor to exceed
the rated value.
(2) Is the Y flexible
Home sensor (1) Is the Y home
or sensor plate
adjustment.
(2) Is the Y home
Motor Does the X-motor
turn smoothly?
Load on the motor Is there anything
was too large. blocking the Y
movement?
8-5
8 TROUBLESHOOTING
Verification item
Lower the cutting
SPEED and/or the
cutting FORCE.
Turn off the plotter,
remove the obstacle,
then turn the plotter
back on.
No .....Check and adjust
slider move
smoothly?
Yes ....Verify item (2).
No .....Connect it
cable securely
connected? Yes ....Replace the Y
Or Is the Y
flexible cable
broken?
No .....Check and adjust
sensor plate
position correct?
Yes ....Replace the
No .....Check and adjust
sensor position
correct?
Yes ....Replace the
No
X-motor if defective.
Yes ....Replace the main
Turn off the plotter,
remove the obstacle,
then turn the plotter
back on.
Solution
the Y belt tension
and Y motor belt
tension.
securely.
flexible cable if
defective.
the X-home
sensor position.
X-home sensor if
defective.
the X-home
sensor position.
X-home sensor if
defective.
R e p l a c e t h e
board if defective.