GRAPHTEC FC8600-60 Service Manual page 50

6 DISASSEMBLY AND REASSEMBLY
How to reinstall the pinch roller sensor
(1) Attach the pinch roller bracket to the pinch roller sensor board.
(2) Connect the pinch roller flexible cable to the pinch roller sensor board.
(3) Attach the pinch roller sensor guard to the pinch roller sensor board bracket.
(4) Attach the pinch roller bracket to the Y-slider.
Fit the top and left edges of the pinch roller bracket to the Y-slider as shown in the figure below.
M3L6 binding head screw
Pinch roller sensor bracket
(5) Attach the pen block (see Subsection 6.2.5).
(6) Reattach the other parts in the reverse order in which they were detached.
FC8600-UM-251-9370 6-18