Fitting Sfp Connectors - Optical Systems Design OSD2251EP Series Operator's Manual

OPTICAL SYSTEMS DESIGN
2.2.10

FITTING SFP CONNECTORS

Care should be taken when inserting/removing the SFP connectors from SFP port 3 and 4 as SFP
modules are Electrostatic (ES) sensitive and Electrostatic Discharge (ESD) precautions should be taken
when installing. Ensure that the SFP is fully engaged and latched into position.
Inserting SFP – Ensure that the SFP lever is in the locked position and insert into appropriate SFP
port. Gently push the SFP until it locks into place. Remove plastic/rubber dust cap and fit fiber cable or
RJ45 plug.
Removing SFP – Remove fiber connector or RJ45 plug. Pull the SFP lever down to unlock SFP from
housing. Using the lever, gently pull the SFP out.
2
1
Fiber SFP
Inserting
Removing
SFP
SFP
2
1
Copper SFP
Inserting
Removing
SFP
SFP
FIGURE 13: FITTING/REMOVING SFP CONNECTORS
DOC ID: 10119201
PAGE 18
OSD2251EP OPERATOR MANUAL