Fitting Sfp Connectors - Optical Systems Design OSD2892 Quick Start Manual

OPTICAL SYSTEMS DESIGN

7 Fitting SFP Connectors

Care should be taken when inserting/removing the SFP connectors from the SFP port as SFP modules
are Electrostatic (ES) sensitive and Electrostatic Discharge (ESD) precautions should be taken when
installing. Ensure that the SFP is fully engaged and latched into position.
Inserting SFP – Ensure that the SFP lever is in the locked position and insert into appropriate SFP
port. Gently push the SFP until it locks into place. Remove plastic/rubber dust cap and fit appropriate
fiber cable.
Removing SFP – Remove fiber connector. Pull the SFP lever down to unlock SFP from housing.
Using the lever, gently pull the SFP out.
2
1
Fiber SFP
Inserting
Removing
SFP
SFP
FIGURE 4: FITTING/REMOVING SFP CONNECTORS
DOC ID: 10118602
PAGE 9
OSD2892 QUICK START GUIDE