S&C BankGuard PLUS Setup Instructions page 28

1011-530
LCD
[N-G Voltage]
[Password]
[UBC In Use]
[Lckout Lvl]
[Lockout Delay]
[Alarm Level]
[Alarm Delay]
[Gross OvrV Level]
[Gross Ovr Delay]
[N-G/L. Ref.
Ratio]
[Ph/TapPt-N Ratio
=]
[InstallType]
[Unbal. Comp.]
[Aux Contact]
[Output Contact
Mode =]
[Alarm Config]
[Nominal Freq.]
[Primary kV]
[Convert UP to %]
[Close Timer]
Table 3. Faceplate abbreviations on the LCD.
Description
Present neutral-to-ground voltage
Password, if required
Unbalance compensation value in use
"Lockout Level" setpoint
"Lockout Time Delay" setpoint
"Alarm Level" setpoint
"Alarm Time Delay" setpoint
"Gross Overvoltage Level" setpoint
"Gross Overvoltage Time Delay" setpoint
"Neutral-to-Ground Ratio" setpoint
"Phase/Tap-Point-to-Neutral Ratio" setpoint
"Installation Type" setpoint
"Unbalance Compensation" setpoint
"Auxiliary Contact" setpoint
"Output Contact Pulse Time" setpoint
"Alarm Contacts Configuration" setpoint
"Nominal Operating Frequency" setpoint
"Rated Primary Phase Voltage" setpoint
"Convert Setpoint Voltages to Percent" set-
point
"Reclose Analog Processing Delay" setpoint
28