Wifi Programming Method - Assa Abloy Norton 6300 Series Programming Instructions Manual

Setup Using WiFi
Follow these steps after operator has been
successfully installed and power has been turned on
(see Page 3, Initial Setup):
1. Turn on Operator Wifi
With cover off:
Using joystick, scroll to WiFi Link menu on LCD
screen. Select ON by pushing joystick RIGHT or
LEFT. Red LED indicates ON. (Figure 11)
With cover on:
Toggle 3 Position switch on end cap 3 times.
(Figure 12)
NOTE:
• Operator will emit a long beep when WiFi has
been successfully turned on.
• WiFi automatically turns off after 20 minutes
of inactivity.
• For further security, WiFi can be turned off
immediately by selecting OFF on LCD screen
or toggling 3 Position switch again. Operator
will emit a short beep when WiFi has been
successfully turned off.
• Operator serial number, password and IP
address are located inside end cap.
(Figure 13)
2. From your smart device open WiFi Networks to
search for operator SSID. Once your specific ID
beginning with NDC6300_ is found, connect to
network.
3. Enter operator password.
4. From your web browser, enter 192.168.1.1 into
search bar.
5. The 6300 Series Operator homepage is indication
of a successful connection. (Figure 14)
6
6300 Series Programming Instructions: WiFi Method
Figure 11
Figure 12
Figure 13
Copyright © 2019, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
WiFi Link
ON (192.168.1.1)
Figure 14
80-9363-0015-020 Rev 1 11/19
Toggle
OFF/ON
3x
BEEP