Onboard Programming Method - Assa Abloy Norton 6300 Series Programming Instructions Manual

Setup Using LCD Screen
Select arm type.
1. Select GO from the Door Setup REQUIRED menu
by pushing joystick to the right. (Figure 4)
2. Depending on your application, select PUSH or
PULL by moving joystick LEFT or RIGHT. (Figure 5)
3. After setting arm type, push joystick UP to
continue Door Setup.
Set door open and door closed positions.
1. To set closed position, fully close door. Press and
release CLOSE button on board. Flashing ORANGE
LED should turn solid. (Figure 6)
NOTE: Any time door is in closed position, orange
LED should be solid.
2. GREEN OPEN LED should now be flashing.
3. To set the fully open position, manually open door to
open position and hold door there.
NOTE: If there is a wall or door stop at open
position, hold door slightly away from wall or stop.
4. Press and release OPEN button on board. Flashing
GREEN OPEN LED should turn solid. Let door close.
(Figure 7)
NOTE: Any time door is in open position, green LED
should be solid.
NOTE: If open position is not set within 30 seconds
of setting closed position, closed position must set
again.
NOTE: Once door has fully closed, make sure there
are no obstructions that could prevent door from
opening. Latching hardware must not prevent
door from opening during following step.
5. Operator must now learn its internal settings. Press
and release LEARN button on board. BLUE LEARN
LED will start flashing and door will open in small
increments. Allow door to open and close without
interference. (Figure 8)
NOTE: After operator has learned settings, if spring
is adjusted or accessories are attached to door that
would make door heavier, operator MUST relearn
internal settings by repeating step 5.
4
6300 Series Programming Instructions: Onboard Method
Door Setup
REQUIRED
Figure 4
Close Door and
Push LEARN Button
Copyright © 2019, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Door Mode
GO
Close Door and
Push CLOSE Button
Figure 6
Open Door and
Push OPEN Button
Figure 7
Figure 8
80-9363-0015-020 Rev 1 11/19
PULL
Figure 5