Table of Contents
Advertisement
MCS-R Control unit
replacing ECS 430P or older control units for
CDM5 & 6
2.4
Programming
Before programming the control unit:
Place the door 1.5m above the floor.
Ensure that the floor is clean and free from cables etc.
Programming can only be carried out using the set of buttons in the control box, not an external push button box or
radio control. For doors with small drums and without safety features, there may be a risk of the wire unwinding. Check
therefore that the wire is located correctly on the drum.
From the main menu it is possible to select the following menu items by pressing the
1) "Language"
2) "Motor setup"
3) "Adjust end position"
4) "Safety devices"
5) "Operating mode"
6) "Code entry"
7) "Special setup"
8) "Service"
Press the
button to enter the selected menu.
2.4.1
Changing the language
The standard language is set to "English". The other languages you can choose from are: Dutch, German, Italian, French,
Spanish, Swedish, Polish, Romanian and Hungarian.
1) Use the
or
2) Press
to enter the menu.
3) Use the
or
4) Press
to confirm and save.
5) Press
to return to the main menu.
6) Press
once more to enter the manoeuvring mode.
MCS-R control unit
buttons to navigate to the "Language" menu.
buttons to select your desired language.
Installation Manual
or
buttons:
8
Hide quick links:
Advertisement
Table of Contents
