Message
Rack height is insufficient.
Unable to set at the specified
location.
Unable to select because unit
exists on right side of the
unit.
Unable to select because unit
exists on left side of the unit.
Enter box code within 8-
alphanumeric characters.
Enter box code within 15
alphanumeric characters.
Install UNLHA32.dll in the
Windows system folder.
ini file has not stored in
program folder, or ini file
loading has failed.
More than on ini files are
stored in the program folder.
One or more setting values in
ini file are incorrect.
BECK tool is already running.
Chapter 1: Installation site considerations
Site Preparation Guide for VSP G/F350, G/F370, G/F700, G/F900
Corrective action
Operate it again at the size shown in the
maximum unit size screen.
If DBX-A is selected, do not set it to the
■
highest place of maximum path in the
logical configuration figure.
If DBX-B is selected, do not set it to the
■
lowest place of the smallest path in the
logical configuration figure.
Set a controller only in Rack 1.
■
Move the unit on the right side of the
■
exchange destination to a different
location and then re-execute.
If DBX is specified in the Select Box
■
dialog box, be sure the cell on the right
side is blank.
Move the unit on the left side of the
exchange destination to a different
location, and then re-execute.
Enter the box code, up to eight
alphanumeric characters.
Enter the box code within 15
alphanumeric characters.
Click the Load Log button after storing the
file UNLHA32.DLL in the Windows system
folder.
Store the INI file in the
■
BECK_Tool_wxyz folder.
Exchange the INI file or the
■
BECK_Tool.exe file.
Store only one INI file in the
BECK_Tool_wxyz folder.
The INI file may be corrupt. Exchange the
INI file.
Confirm whether the BECK tool is not
running.
BECK tool messages
37