Hitachi Virtual Storage Platform G350 Site Preparation Manual page 30

Number
11
12
Working with cable figures
Procedure
1. Click Standard to remove highlights from the SAS (ENC) cables.
2. Click Path0 to highlight SAS (ENC) cables of the unit connected to Path0.
3. Click All Path to highlight SAS (ENC) cables connected to all paths.
4. Click Rack to Rack to highlight the SAS (ENC) cables connected between racks.
5. Click Route0 to highlight the SAS (ENC) cables of the unit connected to the
controller0.
6. Click Route1 to highlight the SAS (ENC) cables of the unit connected to controller1.
7. Click Device ID to display unit IDs.
Use this toggle button to show or hide unit IDs. The box code can be used
regardless of this setting.
8. If the box codes are registered, click Box Code to display the box codes.
Use this toggle button to show or hide box codes. You can use the Device ID button
regardless of whether box codes are shown or hidden.
9. If both the Device ID and Box Code are on, unit IDs and their box codes are
displayed.
10. Click End to close the Cable Figure screen.
Working with cable figures in rack boxes
Procedure
1. Click a drive box in a rack box.
2. The selected unit is highlighted in orange and the units connected to the selected
unit are displayed in white. SAS (ENC) cables connected to the selected unit are
highlighted. All Path of Partial indicates the number of SAS (ENC) cables connected
to the selected unit. Rack to Rack indicates the number of SAS (ENC) cables
connected to the selected unit spanning between racks.
Site Preparation Guide for VSP G/F350, G/F370, G/F700, G/F900
Box Code
End
Chapter 1: Installation site considerations
Working with cable figures
Name
If box codes are assigned
to units, clicking this button
shows or hides the box
codes.
Closes the Cable Figure
screen.
Description
30