Hitachi Virtual Storage Platform G350 Site Preparation Manual page 23

Setting a unit in an empty box in a path
Procedure
1. Right-click an empty box in a path when the logical configuration figure can be
edited.
The clicked box is highlighted in orange and the Select Box dialog box opens.
2. In the Select Box dialog box, click the desired drive tray.
You can optionally enter the box code for the selected drive tray in the Enter box
■
code (optional) box.
3. Click OK.
The selected drive tray appears in the box in the logical configuration figure.
Changing or deleting a drive tray in a path
Procedure
1. Right-click a drive tray in the path.
If you change the type of drive tray type, the existing drive tray is changed or
deleted. You can also edit the box code.
The selected drive tray is highlighted in orange and the Select Box dialog box
opens. The Select Box dialog box shows the selected drive tray. A box code is also
displayed if you registered the system. If you change the Drive Box type, the existing
Drive Box is changed or deleted. You can also edit the Box Code.
Editing box codes for a controller
Procedure
1. In the logical configuration figure, right-click a controller in the path or a box where
you want to set a controller (bottom box of the logical configuration figure).
2. The box is highlighted in orange and the Select Box dialog box opens, with a
controller and box code displayed. If you registered the drive tray, the displayed box
code can be edited. If no controller appears in the configuration screen, click OK to
add a controller to the configuration screen.
3. From here, you can:
Assign a unit in an empty box in a path.
■
Change or delete a drive tray in a path.
■
Assign controllers and edit their box codes.
■
Moving and exchanging drive trays
When editing the logical configuration figure, you can move and exchange units by
dragging and dropping them in the logical configuration figure in ascending order in
paths.
Site Preparation Guide for VSP G/F350, G/F370, G/F700, G/F900
Note: If you click Cable Figure after creating configuration figures, the
cable figure appears. You can also display the cable figure by clicking
Cable Figure without first creating configuration figures.
Chapter 1: Installation site considerations
Setting a unit in an empty box in a path
23