Inspection; Hook Dimensions And Specifications - R&M LOADMATE LM Series Installation And Maintenance Manual

LM01 I&M MANUAL/EN/11.30.2010

5.8.2 Inspection

Inspection for wear on top hook and load hook SHALL be checked routinely. Measure the throat opening.
(dimension-a2). If throat opening exceeds maximum opening allowed, replace hook.
latches SHALL be replaced immediately.
Maximum throat opening allowed:
Hook Class:
Maximum opening allowed:

5.8.3 Hook Dimensions and Specifications

Figure 11. Hook Dimensions
Table 3. Hook Specifications
CAP
CAP tons
kg
1/8 125
1/4 250
Table 4. Hook Dimensions
Ø M Ø a1
Inches 0.551 1.181
mm
14 30
Mark: ISO 2766
DIN 15400 class: T
This document and the information contained herein, is the exclusive property of R&M MATERIALS HANDLING, INC. and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise emplo yed in any manner whatsoever without the express written consent of R&M MATERIALS HANDLING, INC.
Copyright © (2010) R&M MATERIALS HANDLING, INC. All rights reserved.
012P load hook
0.906" [23 mm]
SPECIFICATIONS
TEST
FALLS
kg
1102 1
1102 2
HOOK DIMENSIONS
a2 a3 b1
0.787 1.339 0.748
20 34 19
DIN model number: 15401
DIN 15401 material: 35 CD 4
top hook
0.906" [23 mm]
HOOK
CLASS
012P
012P
b2 e1 h1
0.591 3.268 0.866
15 83 22
Damaged safety
h2 t1 t2
0.748 1.260 0.394
19 32 10
33/65