Visonic POWERMAX PRO Installer's Manual page 8

1
Thick cable entry: Pull out a
desired wiring plastic cap (1
of 4).
Small wiring plastic cap for
thin cable entry: Break the
smaller section of the wiring
plastic cap and insert the
wiring plastic cap back into its
place.
8
Power cable clamp options
For thin For thick cable
cable (reversed clamp)
Insert power cable through the desired wiring channel (see step 1), route it to
the power supply unit and connect its 2 wires to the power supply terminal strip
with screwdriver. Fasten power cable by its clamp (see also step 2 - this clamp
can be reversed to fit thick/thin cable) and close the safety cover.
12.5VDC
Figure 3.1G - Back Unit Power Cable Connection
Extract either of
these cable clamps
for use in the next
step.
Safety
cover
Power
supply
(*)
unit
3
100-240V
50/60Hz
2
DE5468IP