baltur BPM 90 EVO User Instruction Manual page 52

11 DISPLAY UNIT
11.1 Display modes overview
Mode
Operation display
Error display
Information display
Maintenance display
Error memory display
Parametrisation display
Reset display
Entering the password for
parameters set stick
Flashing signal
during normal operation if no error occurs
if the automatic device is switching off due to a fault
pressing the keys (+ and ↵) in the status 1 or 35
pressing the keys (- and ↵) in the status 1 or 35
pressing the keys (+ and ←) in the status 1 or 35
pressing the keys (↵ and ←) in the status 1 or 35
pressing the keys (- and ←) in the operation display
if a new parameters set has to be accepted
Possibility 1: access level change confirmation request
Possibility 2: keep the reset key pressed for more than
5 sec to intentionally restart the MPA.
24 / 30
0006081265_201212
Active if