Mechanical Dimensions; Firmware Update Procedure - Rice Lake MSI-8000 Operation Manual

MSI-8000 RF Remote Display
7.3

Mechanical Dimensions

7.4

Firmware Update Procedure

Updating firmware in the MSI-8000 RF Remote Display requires the following: a DCE serial cable (MSI 503489-0001, or build
per DCE cable schematic on page 28), a PC with a terminal program ("Teraterm Pro" recommended), and if the PC does not
have standard RS-232 serial ports, then a USB to serial converter. Make sure the driver for the USB converter is properly
installed, and that the Terminal program is set up for the proper comm port.
The latest firmware code is available from the MSI Service Department and can be emailed on request. The firmware version
displays when the MSI-8000 RF Remote Display is turned on in form "01-04" (version may vary). MSI-8000 RF Remote Display
firmware updates do not require a recalibration of the connected scale. Consult the version release notes for information
regarding the updated code.
1. Setup the terminal serial port to 8 data bits, No Parity, 1 stop bit, 9600 BAUD, XON/XOFF (flow control).
2. Connect to the Dyna-Link serial port using the DCE cable. Connect the D9 connector to your PC or USB adapter.
3. (Optional) Test that you have a connection by typing {00FF01?}. If the connection is good the MSI-8000 RF Remote
Display will respond with {000001r2;0;01E02;2011-07-08;11:05} or something similar.
4. On the terminal keyboard, type {ffff09=0199} .
www.RiceLake.com
32 Visit our website
8.00''
203.2 mm
3.85''
98 mm
Figure 7-1. Mechanical Dimensions
3.85''
98 mm
1.37''
34.8 mm