Connecting To An Apple Macintosh Series Computer - Yamaha QY100 Owner's Manual

Connecting to an Apple Macintosh Series Computer

Connect the TO HOST connector of the QY100 to the
modem or printer port on your Macintosh, depending on which
port your MIDI software is using for MIDI data communication,
using a standard Macintosh 8-pin system peripheral cable. Set the
HOST SELECT switch to the "Mac" position.
You may also have to make other MIDI interface settings
on the computer side, depending on the type of software you use
(refer to your software owner's manual). In any case the clock
speed should be set to 1 MHz.
"Mac" Cable Connections
TO HOST
connector
MINI DIN
8-PIN
• 8-pin system peripheral cable.
• Data transfer rate: 31,250 bps.
Connecting to an IBM-PC/AT Series Computer
Connect the TO HOST connector of the QY100 to the RS-
232C port on your IBM computer, using a standard 8-pin MINI
DIN 9-pin D-SUB cross cable. Set the HOST SELECT switch to
the "PC-2" position.
Refer to your software owner's manual for information on
any settings you might have to make on the computer side.
"PC-2" Cable Connections
TO HOST
connector
MINI DIN
8-PIN
• 8-pin mini DIN
• Data transfer rate: 38,400 bps.
Power & Connections
1
2
3
4
5
6
7
8
1
2
3
4
8
5
9-pin D-SUB cable.
Modem or
printer port
2 (HSK i)
MINI DIN
1 (HSK 0)
8-PIN
5 (RxD-)
4 GND
3 (TxD-)
8 (RxD+)
7 (GP i)
6 (TxD+)
RS-232C
port
8 (CTS)
D-SUB
7 (RST)
9-PIN
2 (RxD)
5 (GND)
3 (TxD)
17