Yamaha QY100 Owner's Manual page 275

MIDI Buffer Full This will appear when the MIDI reception buffer of the QY100 has
filled up, and processing was not possible. Try decreasing the amount
of data or increasing the interval time and transmit the data once again.
XG Data Error This appears when the received XG parameter change contains a data
size error
XG Adrs Error This appears when the received XG data contains an address error.
XG Size Error This appears when the received XG bulk data contains a data size error.
Checksum Error This appears when the received XG data contains a Checksum error.
Host is OffLine If the QY100 is connected to a computer, this appears when the com-
puter's power is switched OFF. Switch the computer's power ON.
Memory Card
No Name You have attempted to execute a save or load operation without speci-
fying a file or directory name.
No Card This message will appear if you press the [CARD] button when no
memory card is in the QY100 CARD slot (or a card has not been prop-
erly inserted).
Make sure a memory card is properly inserted in the CARD slot before
pressing the [CARD] button.
Card Mount Err An error occurred while accessing the memory card.
Re-insert the card and try again.
Too Many Files This message will appear if you attempt to store 100 or more files and/
or directories in a single directory.
The QY100 can display a maximum of 99 files and directories per direc-
tory.
Too Long Path The directory path (the string of characters that specifies the location
of a directory) is longer than 100 characters.
QY100 directory paths can be up to 99 characters in length.
Not Empty You have attempted to delete a directory that contains one or more
files or other directories.
All files and directories contained in a directory must be deleted before
that directory can be deleted.
Card Write Err An error occurred while writing data to the memory card.
Re-insert the memory card and try again.
Card Protected You have attempted to execute a store or other write operation to a
write-protected memory card.
Remove the write-protect seal from the card and try again.
Same Name Exists When using the Rename or Make Directory function you have entered
a file or directory name that already exists.
Use a different file or directory name.
Read Only File This message will appear if you attempt to write to or delete a read-
only file.
Card Full There is not enough memory available on the card to store the speci-
fied file.
Delete unwanted files from the memory card to make more memory
available, and then try again.
Appendix
275