Volume Control - Yamaha QY100 Owner's Manual

!4 VOLUME Control

The VOLUME control adjusts the volume of the sound
delivered via the LINE OUT/PHONES jack. Slide the control
toward "MAX." to increase the volume or toward "MIN." to
decrease the volume.
CAUTION
• Set the VOLUME control to "MIN." when connecting the QY100 to a
sound system for the first time, then gradually raise the volume level
until the required listening level is reached. This simple precaution can
prevent unexpectedly high volume levels from damaging your speaker
system (and maybe even your ears!).
!5 GAIN Control & PEAK Indicator
Use the GAIN control on the rear panel to adjust the QY100
input gain to match your guitar or microphone. If the PEAK indica-
tor LED next to the [PARAMETER] button light more than just
occasionally as you play or sing, the GAIN setting is too high. The
PEAK indicator should flash only briefly on the highest transient
peaks.
!6 [CARD] Button
Accesses the QY100's memory card functions: Save, Load,
Make Directory, and Format. Settings and sequences can be
saved to and loaded from standard memory cards for convenient,
high-volume storage and portability. The CARD functions are only
available when an appropriate memory card is installed in the
CARD slot on the right side panel. See page 254 for details on the
types of memory cards that can be used and the QY100's card
functions.
!7 [AMP SIMULATOR] Button & Indicator
Turns the specified section(s) of the QY100 amp simulator
stage on or off. The [AMP SIMULATOR] button alternately turns
the amp simulator preamp section (delay effect when a micro-
phone setup is selected), the reverb effect, the chorus effect, or
all three on and off depending on the setting of the "On/Off"
parameter described on pages 44 and 52. The button's indicator
The Controls
( page 254)
( pages 36, 45)
( pages 44, 52)
27