Charging Your Vehicle - Webasto TurboDX User Manual

CHARGING YOUR VEHICLE

Your charger is designed for easy charging at 208/240 VAC.
NOTE
1. Make sure the vehicle is in park and is turned off.
2. Verify the TurboDX EV Charging Station is powered on; if not, turn on power.
3. During startup of the charger, the system will perform a self-test to ensure
correct operation. During this test, the indicator light will briefly flash red
to blue to confirm that the self-test is complete and the unit is ready for
operation. The BLUE STATUS indicator light will stay solid indicating that the
charger is receiving AC power and is ready to charge.
4. Plug the charge coupler into the vehicle's charging inlet until it clicks (IEC
couplers will not click). Once latched, the charge coupler will not disengage
unless the release button is pressed manually (SAE or GB/T couplers only). A
latching detent ensures engagement for IEC couplers.
5. Automatic charge begins. Power will be delivered in accordance with the
vehicle's demand. While the vehicle is charging, the BLUE STATUS indicator will
pulse approximately every two seconds. Always verify that the vehicle charging
status indicator agrees.
6. When fully charged, the BLUE STATUS indicator light illuminates solid blue.
Verify with the vehicle's "dashboard gauge" that the vehicle is fully charged.
Refer to the vehicle owner's manual to find the gauge location on the
dashboard.
7. Disconnect when the charge is complete by pressing the release button on the
charge coupler (IEC and GB/T only) and remove it from the vehicle.
8
The charging capacity is dependent on the ambient temperature.