Mounting Instructions - Bender COMTRAXX CP9 Series Manual

3.2

Mounting instructions

Important mounting instructions:
• The enclosure must be mounted on an even surface!
• The enclosure must not warp during mounting!
• Make sure that the enclosure is mounted at right angles!
• It is recommended to make the wall cutout 3 mm larger than the flush-mounting enclo-
sure!
For installation of the flush-mounting enclosure with bezel frame refer to illustration # 9800267-
01_00 on the subsequent page.
• It is recommended to support the device in the wall, e.g. in an "H" type wall construction
the enclosure should rest on the horizontal beam.
• Before inserting the cables, remove the knockouts or flange plates.
• Lead the power supply cables and control wiring cables into the enclosure.
• Insert the enclosure carefully into the wall cutout.
• Due to the size and weight of the enclosure it is recommended to carry out these steps
with another person.
• The fastening holes can be drilled almost anywhere into the enclosure. Please follow the
instructions in chapter „3.3 Fastening, cable entry".
• The bezel frame has to be sealed all the way around to the wall surface using a durable
elastic seal (e.g. silicone).
• The bezel frame has to be sealed all the way around to the wall surface using a durable
elastic seal (e.g. silicone).
COMTRAXX® CP9xx-x – Control Panel
CP9xx-x_D00406_00_M_XXEN/04.2020 23