Fastening, Cable Entry; Fastening; Cable Entry - Bender COMTRAXX CP9 Series Manual

Customised alarm indicator and operator panel for medical locations and other areas

Hide thumbs Also See for COMTRAXX CP9 Series:

Table of Contents

3.3

Fastening, cable entry

Please observe illustration # 9800373-01_00 on the subsequent page.

• Fastening holes can be drilled into the plastic side pieces of the enclosure (see hatch-

ing). From the enclosure bottom in the area between 8 mm and the calculated value fas-

tening T or from the finished wall surface at a depth greater than 62 mm (see cross sec-

tion illustration).

• Keep the area clear where the adapter plates of the hinges are positioned.

• If fastening holes are required behind the mounting plate, the holes must be counter

sunk to accommodate a counter sunk screw.

• The enclosure bottom plate is equipped with 4 rivet nuts M4x6x11.5 mm. The mounting

plate rests on these rivet nuts and needs to be fastened using a spacer between the

mounting plate and the mounting screw M4x10 mm. Do NOT place the spacer between

the enclosure bottom plate and the mounting plate!

Please observe illustration # 9800373-01_00 on the subsequent page.

• Provisions for cable entry are made as per customer specification. Generally, they are lo-

cated at the top of the side panels. (see cross section illustration below).

• If there are no requests from the customer, additional cable entry holes can be drilled

into the enclosure. From the enclosure bottom in the area between 8 mm and the calcu-

lated value fastening D or from the finished wall surface at a depth greater than 62 mm

(see cross section illustration).

COMTRAXX® CP9xx-x – Control Panel

CP9xx-x_D00406_00_M_XXEN/04.2020

Table of Contents