Removing The Front Plate Of Cp915 And Cp924 - Bender COMTRAXX CP9 Series Manual

Customised alarm indicator and operator panel for medical locations and other areas

Hide thumbs Also See for COMTRAXX CP9 Series:

Table of Contents

Mounting and connection

3.1.3 Removing the front plate of CP915 and CP924

The front plate is removed from the enclosure of the CP915 and CP924 alarm indicator and opera-

tor panel by means of a suction lifter. For this purpose, the tool must be placed at the points

marked below and the front plate must be removed until it clicks into place for the first time. If

the front plate is detached at all four corners, the plate can be lifted off the enclosure.

! Damage to the glass front plate with touch monitor!

aution

For the CP915-G and CP924-G alarm indicator and operator panels, use only the suction lifter

for CP9xx displays (B95061911). If this is not observed, the front plate may slip off and the glass

plate with touch monitor may fall down and break.

CP9xx-x_D00406_00_M_XXEN/04.2020

Table of Contents