Assembly - Grizzly G0661 Owner's Manual

Assembly

To assemble the table saw:
1.
attach the upper stand braces to the top holes
of the left and right legs with eight M8-1.25 x
12 carriage bolts, 8mm flat washers, and
M8-1.25 hex nuts, as shown in Figure 14.
just hand tighten the fasteners for this step.
upper stand
Brace
x 8
right
Figure 14. upper stand brace secured to legs.
2. attach the lower stand braces to the leg
assemblies from Step 1 with four M8-1.25
x 12 carriage bolts, 8mm flat washers, and
M8-1.25 hex nuts, as shown in Figure 15.
just hand tighten the fasteners for this step.
Note: Make sure the upper stand brace with
the Grizzly logo is on the same side as the
lower stand brace with the model number
label.
lower stand
Brace
Figure 15. lower stand brace secured to legs.
-24-
3.
horizontal Brace
left
4.
M8-1.25
hex nut
Figure 17. Foot installed with hex nuts and flat
x 4
attach both leg assemblies together with
the remaining side stand braces and eight
M8-1.25 x 12 carriage bolts, 8mm flat wash-
ers, and M8-1.25 hex nuts, as shown in
Figure 16. just hand tighten the fasteners for
this step.
x 8
Figure 16. stand assembly completed.
use M8-1.25 hex nuts and 8mm flat washers
to attach each foot to the bottom of the stand,
as shown in Figure 17.
Note: Adjust the hex nuts to approximately
the same position on the threaded shaft of
the feet during this step to make leveling
easier during a later step.
washers.
Model g0661/g0713 (Mfg. since 1/10)
Foot
8mm Flat
Washer