Table of Contents
Advertisement
Mounting Featherboards w/Clamps
1.
lower the saw blade, then adjust the fence to
the desired width and secure it.
2.
place the workpiece against the fence, mak-
ing sure it is 1" in front of the blade.
3.
place a featherboard on the table away from
the blade so all fingers point forward and
contact the workpiece (see Figure 78).
Fence Featherboard
Clamp
table
Featherboard
Figure 78. Example of featherboards secured
with clamps.
4.
secure the featherboard to the table with a
clamp.
5.
Check the featherboard by pushing it with
your thumb to ensure it is secure.
— if the featherboard moves, tighten the
clamp more.
6.
Mount a second featherboard to the fence
with another clamp (see Figure 78), then
repeat Step 5 to ensure it is secure.
Model g0661/g0713 (Mfg. since 1/10)
Mounting Featherboard in Miter Slot
1.
lower the saw blade, then adjust the fence to
the desired width and secure it.
2.
place the workpiece evenly against the fence,
making sure it is 1" in front of the blade.
3.
slide the featherboard miter bar into the miter
slot, making sure the fingers point toward the
blade, as shown in Figure 79.
Clamp
Figure 79. Featherboard installed in miter slot
and supporting workpiece for ripping cut.
4.
position the fingered edge of the feather-
board against the edge of the workpiece, so
that all of the fingers contact the workpiece.
slide the featherboard toward the blade until
the first finger is nearly even with the end of
the workpiece, which should be 1" away from
the blade.
5.
double check the workpiece and the feather-
board to ensure they are properly positioned
as described in Step 4. then secure the
featherboard to the table. Check the feather-
board by hand to make sure it is tight.
Note: The featherboard should be placed
firmly enough against the workpiece to keep
it against the fence but not so tight that it is
difficult to feed the workpiece.
-55-
Advertisement
Table of Contents
