Table of Contents
Advertisement
Blade Installation
review this section, even if your saw blade came
pre-installed.
To install a new blade:
1.
disConnECt saW FroM poWEr!
2.
put on heavy leather gloves and raise the
arbor all the way up.
3.
remove the table insert and blade guard/riv-
ing knife, depending on what is installed.
Before proceeding with the next step, wear
gloves to protect your hands while handling
and installing the blade.
4.
use the arbor wrenches to loosen and remove
the arbor nut, flange, and blade. Note: The
arbor nut has right hand threads; turn it coun-
terclockwise to loosen.
-36-
5.
slide the blade over the arbor with the teeth
facing the front of the saw, as shown in
Figure 45.
Figure 45. Example of correct blade direction
and blade components installation order.
6.
re-install the arbor flange and the arbor nut,
then tighten them against the blade with the
wrenches included with the saw, as shown in
Figure 30. do not overtighten.
Figure 30. Example of securing blade.
7.
reinstall the blade guard/riving knife and the
table insert.
Model g0661/g0713 (Mfg. since 1/10)
Advertisement
Table of Contents
