Table of Contents
Advertisement
Voltage Conversion
this section shows how to convert the Model
g0661 from 220V to 110V and the Model g0713
from 110V to 220V.
Items Needed
•
phillips head screwdriver #2 ..................... 1
•
Electrical tape ............................ as needed
•
Wire nut (14 aWg x 3) .............................. 1
•
5-20 plug (g0661) or 6-15 plug (g0713) .. 1
NOTICE
Refer to the motor junction box cover dia-
gram for connection locations and voltage
conversion. If a diagram is not present,
use the instructions below, or call our Tech
Support Department at (570) 546-9663.
Converting G0661 to 110V
1.
disConnECt saW FroM poWEr!
2.
open the motor junction box, then loosen the
wire nuts indicated in Figure 5.
Figure 5. location of wire nuts to be loosened
on Model g0661.
3.
use wire nuts to connect the wires as indi-
cated in Figure 6. twist both wire nuts onto
their respective wires and wrap them with
electrical tape so they will not come loose.
4.
Close and secure the motor junction box.
5.
remove the pre-installed 6-15 plug from the
power cord and install a 5-20 plug on the end
of the cord, as illustrated in the wiring dia-
gram on page 78.
-18-
Qty
Converting Model G0713 to 220V
1.
2.
Figure 7. location of wire nuts to be loosened
3.
loosen
these
Wire nuts
4.
5.
Figure 6. Model g0661 rewired to 110V.
disConnECt saW FroM poWEr!
open the motor junction box, then loosen the
wires indicated in Figure 7.
on Model g0713.
use wire nuts to conect the wires as indicated
in Figure 8. twist both wire nuts onto their
respective wires and wrap them with electri-
cal tape so they will not come loose. retain
the wire nut on the brown wire.
Figure 8. Model g0713 rewired to 220V.
Close and secure the motor junction box.
remove the 5-15 plug from the power cord
and install a 6-15 plug (refer to wiring dia-
gram on page 79).
Model g0661/g0713 (Mfg. since 1/10)
Connect
Wires with
nuts here
loosen
these
Wire nuts
Connect
Wires with
nuts here
Advertisement
Table of Contents
