Table of Contents
Advertisement
8.
plug in the table saw, turn it ON, and use a
push stick or push block to feed the workpiece
through the blade, using a slow and steady
feed rate.
9.
Flip the workpiece end for end, keeping the
same side against the fence, and run the
workpiece through the blade.
10. repeat Steps 7–9 until the blade is close to
half of the height of the board to be resawn.
the ideal completed resaw cut will leave an
⁄
" connection when the resawing is com-
1
8
plete as shown in Figure 73. leaving an
connection will reduce the risk of kickback.
Figure 73. ideal completed resaw cut.
-52-
11. turn OFF the table saw, then separate the
parts of the workpiece and hand plane the
remaining ridge to remove it.
12. When finished resawing, remove the resaw
barrier and auxiliary fence, then re-install the
blade guard/spreader or riving knife and stan-
dard table insert.
⁄
"
1
8
Model g0661/g0713 (Mfg. since 1/10)
Advertisement
Table of Contents
