insys icom GSM small 2.0 Manual page 73

INSYS GSM small 2.0
Command
AT+CGACT=[<stat
e>[,<cid>[,<cid
>[,...]]]]
AT+CGDATA=[<L2P
>[,<cid>[,<cid>
[,...]]]]
AT+CGDCONT?
AT+CGDCONT=[<ci
d>[,<PDP_type>[
,<APN>[,<PDP_ad
dr>]]]]
AT+CGQMIN?
AT+CGQMIN=[<cid
>[,<precedence>
[,<delay>[,<rel
iabil-
ity>[,<peak>[,<
mean>]]]]]]
Description
Enable/disable PDP context
0 PDP context indicated with <cid> disabled (default)
<state>
1 PDP context indicated with <cid> enabled
Index of a PDP context (refer to AT+CGDCONT) to be enabled /
<cid>
disabled
Starting a GPRS connection
Layer 2 Protocol between application and GPRS engine
<L2P>
1 PPP
Index of a defined PDP context (refer to AT+CGDCONT) to be
<cid>
enabled / disabled
If the command is executed successfully, the message "CONNECT" indi-
cates that data mode is enabled with the control line DCD.
The command ATD allows to perform a modem-compatible GPRS connec-
tion establishment as well.
Reading out the PDP context
Defining the PDP context
Index, which identifies the respective PDP context
<cid>
1 PDP context 1
2 PDP context 2
<PDP_type> Protocol type of the packet transmission
IP Internet protocol
Access Point Name as string. Must be in quotation marks.
<APN>
<PDP_addr> String that indicates the address for identifying the GPRS
terminal device in the address space (IP V4 address for
PDP_type IP). If not entered, the application can enter it
during the PDP start procedure or a dynamic IP address is
requested.
The commands AT&F or ATZ will set disabled contexts to undefined.
The setting is not stored with AT&W.
Displaying the Quality of Service profile (minimum acceptable)
Defining the Quality of Service profile (minimum acceptable)
Only if this QoS profile of the terminal device is at least supported by the
provider, the GPRS connection will be established.
Index of a defined PDP context (refer to AT+CGDCONT), for
<cid>
which this minimum profile is to be valid.
<precedence> Priority class
0 Network subscribed value (default)
1 High priority;
AT Command Reference
73