Automated Pin Entry And Login After Restart - insys icom GSM small 2.0 Manual

INSYS GSM small 2.0
11.11.1

Automated PIN entry and login after restart

This function allows a login into the GSM network and the transfer of the PIN by
the INSYS GSM small 2.0.
Configuration with HSComm
The simplifies PIN entry using the HSComm software is described in the
Entering the PIN of the SIM card section.
Configuration with AT commands
In order to configure an automated login
into the GSM network, use the command
Replace <time> with the time, which must
expire before the login, in the format
<hhh:mm:ss> (e.g. <000:00:06> for
6 seconds upon restart).
In order to configure an automated PIN
transfer, use the command
Replace <PIN> with the PIN of the SIM
card and <time> with the time, which
must expire before transferring the PIN, in
the format <hhh:mm:ss> (e.g.
<000:00:10> for 10 seconds upon restart).
After the configured time has expired fol-
lowing a restart, the response at the serial
interface is
Then, the INSYS GSM small 2.0 is logged in
into the GSM network.
In order to disable the automated login into
the GSM network, use the command
In order to disable the automated PIN trans-
fer, use the command
All settings configured with the command AT^SCFG will only be saved af-
ter executing the command AT^SMSO.
In order to save the settings, use the com-
mand
AT^SCFG="AutoExec",1,1
,0,0,"AT+COPS=0","<tim
e>"
AT^SCFG="AutoExec",1,1
,1,0,"AT+CPIN=<PIN>","
<time>"
^SCFG: "Auto-
Exec",1,1,0,0,"AT+COPS
=0"
^SCFG: "Auto-
Exec",1,1,1,0,"AT+CPIN
=<PIN>"
AT^SCFG="AutoExec",0,1
,0
AT^SCFG="AutoExec",0,1
,1
AT^SMSO
Functions
49