Sleep Modes - insys icom GSM small 2.0 Manual

INSYS GSM small 2.0
11.12.3

Sleep Modes


The sleep modes only work correct, if the PIN authentication of the
SIM card has been performed. Either by entering the PIN with
AT+CPIN or by disabling the PIN request.
11.12.3.1 Sleep Mode Off (Normal Mode)
Configuration with HSComm
A configuration of this functio
sible.
Confi guration with AT command
In order to disable sleep mode, use the
command
11.12.3.2 Non-Cyclic Sleep Mode
The serial interface is disabled in this sleep mode. Every "wake-up event", which is
possible in this mode, (except AT commands) causes the INSYS GSM small 2.0 to
change into normal mode.
Configuration with HSComm
A configuration of this function using the HSComm software is not pos-
sible.
Configuration with AT commands
In order to enable non-cyclic sleep mode,
use the command
n using the HSComm software is not pos-
s
AT+CFUN=1
AT+CFUN=0
Functions
57