Shutdown Mode; Operation With A Plc - insys icom GSM small 2.0 Manual

INSYS GSM small 2.0
11.12.5

Shutdown mode

The shutdown mode is hardware-activated by connecting the reset input with GND
for at least 10 seconds.
The shutdown mode will be left, as soon as the connection between reset input
and GND is disconnected again. The INSYS GSM small 2.0 will be restarted.

11.13 Operation with a PLC

The INSYS GSM small 2.0 can be operated at a programmable logic controller. Set-
tings recommended by INSYS for a INSYS GSM small 2.0, which is used at the PC
to communicate with the PLCs, are available for certain controllers. The respective
configuration files can be found under http://www.insys-tec.de/en/en/plc/ or in the
"Configuration for PLC" section of the CD delivered with the unit.
Configuration with HSComm
You may load presetting files into HSComm under the menu item "PLC".
Moreover, you can store settings for the PLC to a file. You can transfer
these settings to the INSYS GSM small 2.0 then.
Configuration with AT commands
You can also perform these settings with
AT commands. The settings depend on you
PLC and cannot be given here generally
therefore.
Functions
61