Establishing A Ppp Data Connection - insys icom GSM small 2.0 Manual

INSYS GSM small 2.0
In order to configure the number of ring tones
after which the INSYS GSM small 2.0 answers
and accepts the connection, use the command
Replace <n> with the number of ring tones (<n>
= 2...255, <n> = 0 deactivates the function).
Take the AT&D setting in account.
In order to change to command mode during a
data connection, use the escape sequence
No data must be transmitted for 1 second be-
fore and after that the INSYS GSM small 2.0
changes to command mode.
In order to change from command mode to
normal data transmission again, use the com-
mand
In order to terminate a connection and cause the
INSYS GSM small 2.0 to hang up, use the com-
mand
Terminating the connection via DTR Drop might
also be possible.
11.8

Establishing a PPP Data Connection

Information about establishing a PPP data connection can be found in the add-on
manual INSYS GPRS/EDGE Devices as GPRS/EDGE Terminal on the enclosed CD.
Functions
ATS0=<n>
+++
ATO
ATH
45