HOST MODE PROGRAMMING
The 'Restore Default Configuration' programming command must have the
following format:
Where:
SD:
DEFNUM:
After entering this command, the device responds with the proper reply message and
then waits for one or more programming strings.
If the programming is correct, the device updates the configuration and confirms with
the following message:
Where:
DEFNUM:
If programming contents are wrong (i.e. a typing error in the file) or due to a
transmission error, the device replies with the following message:
Where:
ERRCODE:
The complete Error Codes table is provided in the Paragraph 5.3.
This programming command will be applied on all Configuration and
Environmental parameters. Refer to the Genius Help On Line of the
selected device for further details.
SD<space>DEFNUM<CR><LF>
Restore Default configuration command
Default configuration number. The only possible value is
currently:
0 = Factory Default
Y<space>DEFNUM<CR><LF>
Default
N<space>ERRCODE<CR><LF>
Error Code (signed DEC value)
WARNING
17