Address Settings On Twinsafe Terminals With 1023 Possible Addresses; Registering The Twinsafe Addresses In The Twincat Automation Software; Fig. 16 Address Settings On Twinsafe Terminals With 1023 Possible Addresses; Fig. 17 Registering The Twinsafe Addresses In The Twincat Automation Software - Beckhoff EL6900 Operating Instructions Manual

Operation
4.4.5 Address settings on TwinSAFE terminals with 1023 possible
addresses
Fig. 16: Address settings on TwinSAFE terminals with 1023 possible addresses
The TwinSAFE address of the terminal is set via the 10-way DIP switch on the left-hand side of the
TwinSAFE terminal. TwinSAFE addresses between 1 and 1023 are available.
DIP switch
1 2 3
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
... ... ...
ON ON ON
TwinSAFE address
Each TwinSAFE address may only be used once within a network / a configuration!
The address 0 is not a valid TwinSAFE address!
WARNING
4.4.6 Registering the TwinSAFE addresses in the TwinCAT
automation software
The TwinSAFE address set at the DIP switch must also be entered under the TwinSAFE Logic tab
(TwinSAFE address entry).
32
4 5 6
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
... ... ...
ON ON ON
Version: 2.2.0
7 8 9
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
... ... ...
ON ON ON
Address
10
OFF 1
OFF 2
OFF 3
OFF 4
OFF 5
OFF 6
OFF 7
... ...
ON 1023
EL6900