Figure 9-8 Gtr 8000 Power Amplifier Rf Cable (Front) - Motorola GTR 8000 Manual

GTR 8000 Base Radio
7 Remove the RF output QN connector from the front of the power amplifier module, as follows.
a. Pull the power amplifier out of the chassis far enough so that the QN (quick-N) RF output connector is
accessible.
b. Disconnect the cable from the power amplifier.

Figure 9-8 GTR 8000 Power Amplifier RF Cable (Front)

Using the handle, gently pull the power amplifier module straight out, along the guides on which it sits.
8
9 Reconnect the RF cable to the RF output QN connector on the front of the power amplifier module, as follows:
a. While holding the RF cable, slide in the replacement power amplifier module along the guiding rails until
the RF cable connector can reach the RF connection on the front of the module.
b. Push the RF cables connector on to the module's connector until it snaps securely into place.
10 Slide in the replacement power amplifier module until it engages with the backplane. A slight push may be
needed to engage the module.
If the power amplifier module stops well before it is engaged, it is in an incorrect position. Either it is
in the wrong slot or it is rotated 180°.
11 Secure the power amplifier module to the chassis with the two captive screws on the front of the module.
12 Reinstall the fan unit. See
If you chose to turn off the power, set the rocker switch on the front of the associated power supply
to the On (1) position.
9-20
9.3 Replacing the Fan Assembly, page 9-10.
6871022P86-A - November 2012