Setting Up The Hpd Service Monitor For Testing The Base Radio; Figure 5-24 Hpd Service Monitor Test Screen (Aeroflex 3900 Series Service Monitor) - Motorola GTR 8000 Manual

GTR 8000 Base Radio

Figure 5-24 HPD Service Monitor Test Screen (Aeroflex 3900 Series Service Monitor)

The HPD Service Monitor may be connected with an HPD base radio to perform the following diagnostic tests
(for additional tests, see the HPD service monitor manual). These tests are designed to determine whether the
equipment is operating within specification. Service may be required on an HPD base radio if it fails to meet
specification. Topics cover include:
• 5.11.3 Measuring HPD BR Tx Power, Frequency Accuracy and Tx EVM, page
• 5.11.4 Measuring HPD BR Rx Sensitivity and Rx BER, page
• 5.11.5 Checking Receiver Sensitivity (Self-test Method) (HPD), page 5-57
For additional information about using the service monitor, see the HPD Service Monitor manual or online help
(accessed through the Help button on the front of the service monitor).
5.11.1 Setting Up the HPD Service Monitor for Testing the
Base Radio
Procedure Steps
1 Plug a power cable into the AC port at the rear of the service monitor.
2 Connect a USB mouse to one of the two USB ports in the rear of the service monitor.
The following procedures assume a USB mouse is connected. If not, for instructions to click or select you
can use the TAB and arrow buttons on the front of the service monitor. For instructions to select a soft key
on the right side of the screen, use the unlabeled buttons on the front of the service monitor, pressing the
button located next to the soft key on the screen.
5-46
5-49.
5-52.
6871022P86-A - November 2012