Motorola GTR 8000 Manual page 302

GTR 8000 Base Radio
Make sure to Restore the Clear Protocols parameters.
g. Enable RADIUS Authentication using the CSS. See Chapter 7, "Configuring RADIUS Sources and
Parameters Using CSS" in the Authentication Services manual.
h. Enable Centralized Authentication using the CSS. See Chapter 7, "Enabling/Disabling Centralized
Authentication Using CSS" in the Authentication Services manual.
i. Set the Local Cache Size for Centralized Authentication using the CSS. See Chapter 7, "Setting the Local
Cache Size for Central Authentication Using CSS" in the Authentication Services manual.
j. Enable Centralized Event Logging using the CSS (if required by your organization). See Chapter 6, "How to
Enable/Disable Centralized Event Logging on Devices Using CSS" and Chapter 1, "Event Logging Client
Configuration" for proper hostnames in the Centralized Event Logging manual.
k. Set the NTP Server Settings. See
5 Perform a site software download (SWDL) with the SNMPv3 package (if SNMPv3 is desired) of the device
and associated site devices. Refer to one of the following procedures:
• Trunked GTR 8000 Base Radios:
– For GTR 8000 Base Radios with PSC 9600 Site Controller:
– For GTR 8000 Base Radios with GCP 8000 Site Controller:
• Conventional GTR 8000 Base Radios: See "Downloading Software" in the Software Download
manual. To perform the software download operation, follow the "Performing Operations on a Single
Off-line Device" procedure.
6 Restore Codeplug Archive from backup. Reload the base radio configuration file on the new base radio using
CSS, as follows:
a. Select File → Open from the menu. Locate and open the previously saved configuration file for the
base radio.
If you were not able to back up the base radio configuration from the previous base radio, you can
use the configuration from your system build book or use the default base radio configuration file.
Specific settings for the base radio must still be configured. See the CSS Online Help.
b. Click OK on the Properties Window.
c. Select File → Write Configuration To Device from the menu. Click OK.
11-2
PSC 9600 Site Controllers, page
With GCP 8000 Site Controllers, page
For a conventional base radio, software download should be done independently choosing
SINGLE DEVICE mode.
4.4.5.7 Setting the NTP Server Settings, page
11-3.
11-5.
4-24.
11.2 Performing a Site Download With
11.3 Performing a Site Download
6871022P86-A - November 2012