Motorola GTR 8000 Manual page 270

GTR 8000 Base Radio
24 Reinstall the fan assembly. See
25 Slide the power supply into the chassis, pushing gently until it seats in the new backplane.
If the power supply does not seat properly, remove it and adjust the EMI spring panel properly against the
mounting flange.
26 Tighten the two captive screws on the front of the power supply.
27 Reconnect all cables at the rear of the base radio.
28 Set the power supply rocker switch to On (1).
29 Verify that the LEDs indicate the modules you removed and reinstalled are operational.
• The Status LEDs are green.
• The Alarm LEDs are off.
• The power supply Fan LED is off.
30 In CSS, enable the base radio as follows:
a. Select Service → Test Measurement Screen from the menu.
b. Click Change to Normal Mode.
Step result: The channel is enabled.
31 Re-configure the Security Settings into the Backplane. See
Using CSS, page
32 Verify proper operation using software tools, including:
• Unified Event Manager.
• Configuration/Service Software (CSS).
9-26
9.3 Replacing the Fan Assembly, page
4-9.
9-10.
4.4.3.3.1 Setting the Serial Security Services
6871022P86-A - November 2012