System Manager; Putting Into Service - Riello Steel Pro Power 114-2 P Installation, Technical Assistance Service And System Management Manual

SYSTEM MANAGER

7 SYSTEM MANAGER
7.1

Putting into service

9
The appliance must be maintained and adjusted at least
once a year by Technical Assistance Service or by profession-
ally qualified staff in compliance with all applicable Nation-
al and Local provisions.
9
Incorrect maintenance or adjustment may damage the ap-
pliance and cause damage to people or create a hazard.
9
The system manager is forbidden from opening and remov-
ing the appliance's casing. These activities must be carried
out only by Technical Assistance Service or by professionally
qualified personnel.
The thermal module Steel Pro Power
sioned by Technical Assistance Service
appliance may operate automatically.
However, the system manager may be required to restart the
appliance independently, without involving Technical Assistance
Service; for example after a long period of absence.
To do so, perform the following checks and operations:
− Check that the gas cock and heating water cock are open
− While the system is still cold, check that working pressure
in the central heating circuit is over 1 bar but below the
maximum limit specified for the boiler
− Adjust the room thermostats for the high and low tem-
perature zones to the required temperature (~20°C) or,
if the systems are equipped with timer thermostats or a
time programming unit, make sure it is on and adjusted
(~20°C)
R must be commis-
R , after which step the
101
− Switch the system's master switch to the ON position and
the thermal module's master switch to (I).
The appliance will go through the switch-on stage and, after
starting, it will continue to operate until set temperatures are
achieved.
The burner will then switch off and on automatically to main-
tain the set temperature without further operator action.
In the event of ignition or operation faults, the display will show
a numeric error code that will enable the user to interpret the
possible cause as detailed in Paragraph "Error List".
9
In the event of a permanent error, to reset starting condi-
tions press the "RESET" key and wait for the thermal module
to restart.
Repeat this operation 2-3 times at the most. If the problem per-
sists after that, call 's Technical Assistance Service.
R
SYSTEM MANAGER
System manager