Information On The Operation Of The Zone - Riello Steel Pro Power 114-2 P Installation, Technical Assistance Service And System Management Manual

MANAGING ADDITIONAL ZONE
6.7

Information on the operation of the zone

By going to:
Menu → "Information" → "Zone Status"
External Zone Status 1
" "
External Zone
" "
To choose the zone whose information will be displayed, pro-
ceed in the same way as in the previous paragraph.
Once the ● key is selected the following display appears:
External Zone 1
" "
Error
" "
RT Input
" "
Zone Setpoint
" "
Flow Temperature
" "
External Zone 1
" "
Zone Setpoint
" "
Flow Temperature
" "
Valve
" "
Pump
" "
1
255
p
No
" "
-10.0 °C
" "
25.5 °C
" "
-10.0 °C
p
" "
25.5 °C
" "
0%
Off
" "
The information displayed is the following:
Error code Description
Indicates the error code of the board (255 = no
Err
error)
Indicates whether there is a request (namely, if
Input Heat the contact for the heat request is open (NO, no
request) or closed (Yes, request present)
Zone set-
Indicates the zone setpoint
point
Delivery Indicates the temperature measured by the
temperature zone probe
Indicates the opening percentage of the valve
Valve
(100% = fully open)
Indicates if the pump is stopped (off) or active
Pump
(on)
Zone board errors table:
Error code Description
22 Zone probe disconnected
23 Zone probe short-circuit
Overtemperature detected
24 (opening of safety thermo-
100
Solution
Check probe
Check probe
Check parameters
Check operation of
stat) mixer