Fuji Xerox DocuPrint CP315 dw User Manual page 58

▌
[Administrator Menu] > [Maintenance Mode] >
[Clean Marking Units]
Cleans the developer and the transfer unit. This setting is useful for resolving a fog problem on printouts.
▌
[Administrator Menu] > [Maintenance Mode] >
[Toner Refresh]
Ensures a proper balance between toner and developing powder. This setting is useful for resolving a fog
problem on printouts.
Note
• This feature uses the toner, and shorten the life of the toner cartridges and the drum cartridges.
▌
[Administrator Menu] > [Maintenance Mode] >
[Initialize NVM]
Initializes the non-volatile (NV) memory. After executing this setting and restarting the printer, all the menu
parameters are reset to their default values.
▌
[Administrator Menu] > [Maintenance Mode] >
[Initialize Print Meter]
Initializes the print meter of the printer. When the print meter is initialized, the meter count is reset to zero.
▌
[Administrator Menu] > [Maintenance Mode] >
[Clear Job History]
Clears the job history of all finished jobs.
▌
[Administrator Menu] > [Maintenance Mode] >
[Clear Stored Jobs]
Note
• This setting is available only when [RAM Disk] is enabled.
Clears print jobs saved using the stored print feature.
[All Documents]
[Secure Documents]
[Stored Documents]
▌
[Administrator Menu] > [Maintenance Mode] >
[Non-Genuine]
Specifies whether to use toner cartridge of another manufacturer.
Important
• Using a non-Fuji Xerox toner cartridge may severely damage the printer. The warranty does not cover damages caused
by using a non-Fuji Xerox toner cartridge.
▌
[Administrator Menu] > [Maintenance Mode] >
[Adjust Altitude]
Specifies the altitude of the location where the printer is installed.
The discharge phenomenon for charging the photo conductor varies with barometric pressure. Adjustments are
performed by specifying the altitude of the location where the printer is being used.
Note
• An incorrect altitude adjustment setting leads to poor printing quality, incorrect indication of remaining toner, etc.
58
User Guide
Deletes all print jobs saved using the stored print feature.
Deletes print jobs saved using the Secure Print feature.
Deletes print jobs saved using the Sample Set feature.