Fuji Xerox DocuPrint CP315 dw User Manual page 151

Problem
The printed result is foggy.
Bead-Carry-Out (BCO)
Action
1 If the whole page of the printout is light, contact Fuji Xerox local
representative office or an authorized dealer. If not, proceed to step 2.
2 Clean the developer and print a Demo Page for verification.
Refer
• For details, see "[Clean Marking Units] (P.58)" and "[Demo Page]
(P.44)."
If the problem persists, proceed to step 3.
3 Ensure a proper balance between toner and developing powder, and print a
Demo Page for verification.
Refer
• For details, see "[Toner Refresh] (P.58)" and "[Demo Page] (P.44)."
Note
• This feature uses the toner, and shorten the life of the toner cartridge
and the drum cartridge.
If the problem persists, proceed to step 4a or 4b.
4a If you use a non-Fuji Xerox toner cartridge, enable the non-genuine toner
option.
Refer
• For details, see "Non-Genuine Mode (P.170)."
If the problem persists, proceed to step 5.
4b If you use a Fuji Xerox toner, replace the drum cartridges and print a Demo
Page for verification.
Refer
• For details, see "Replacing the Drum Cartridges (P.103)" and "[Demo
Page] (P.44)."
If the problem persists, contact Fuji Xerox local representative office or an
authorized dealer.
5 Replace the toner cartridge with a Fuji Xerox toner and print a Demo Page for
verification.
Refer
• For details, see "Replacing the Toner Cartridges (P.101)" and "[Demo
Page] (P.44)."
If the problem persists, contact Fuji Xerox local representative office or an
authorized dealer.
151
7 Troubleshooting