Table of Contents
Advertisement
POWER SUPPLY OF THE DEVICE
1. Disconnect the battery compartment (Fig.2).
2. Install two "AA" batteries in the compartment.
Make sure that polarity corresponds to signs (+) and (-) shown inside the
compartment (Fig. 3).
Batteries are readily installed by pressing the end "-" on the spring.
3. Close the battery compartment.
Do not use excessive force when removing the cover.
Battery Replacement Indicator
Replace all the batteries when the battery replacement indicator is fl ashing on the display during the measurement. If upon the
device turning on the indicator is steadily fl ashing, the measurement will not be possible until all the batteries are replaced. The battery
replacement indicator does not show a discharge degree.
Use alkaline batteries to increase the device operation duration. Ordinary zinc-carbon batteries require more frequent replacement. The enclosed
batteries are meant for testing the sold device, and their operation period can be less than that of batteries acquired in the trade network.
Since neither the device nor the batteries are the waste that can be utilized at home, follow your national/local regulations for waste recy-
cling and take them to corresponding collection faciliti
SETTING DATE AND TIME
Date and time can be set after installing batteries. Setting the date and time guarantees the preservation of measurement results with indicated
correct date and time. The device can be used without setting the date and time.
Press and hold the SET button until the display fl ashes the value of the year
minute
.
es
Date and time are set in the following order: year, month, day, hour and
.
6
Fig.2
Fig.3
Advertisement
Table of Contents
