Setting Date And Time - Nissei DSK-1031 Instruction Manual

urement should be carried out in a quiet comfortable atmosphere at room tem-
perature. Exclude meal an hour before the measurement, and exclude smoking, soft
drinks, and alcohol 1.5-2 hours before the measurement.
7. Accuracy of the blood pressure measurement depends on matching the device
cuff and size of your hand. THE CUFF SHOULD NOT BE TOO SMALL OR TOO BIG.
8. Repeated measurements are carried out at 5-minute intervals to recover the
blood circulation. However, persons suff ering from severe atherosclerosis, due to a
signifi cant loss of elasticity of blood vessels, need longer intervals between meas-
urements (10-15 minutes).
This also concerns patients suff ering from long-term diabetes. For more accurate deter-
mination of blood pressure it is recommended to carry out a series of three consecutive
measurements and to calculate the average value of measurement results.
POWER SUPPLY OF THE DEVICE
INSTALLATION OF BATTERIES
Fig.2
Allowed to rechargeable batteries. To charge the batteries, use the special charger
(not included).
3. Close the battery compartment. Do not use excessive force when removing the cover.
Do not use excessive force when removing the cover.
1. Open the battery compart-
ment (Fig. 2).
2. Install four "AA" batteries in
the compartment.
Make sure that polarity corre-
sponds to signs (+) and (-) shown
inside the compartment (Fig. 3).
Batteries are readily installed
by pressing the end "-" on the
Fig.3
spring.
Battery Replacement Indicator
Replace all the batteries when the battery replacement indicator is fl ashing on
the display during the measurement. If upon the device turning on the indicator
is steadily fl ashing, the measurement will not be possible until all the batteries are
replaced. The battery replacement indicator does not show a discharge degree.
Use alkaline batteries to increase the device operation duration. Ordinary zinc-carbon
batteries require more frequent replacement. The enclosed batteries are meant for
testing the sold device, and their operation period can be less than that of batteries
acquired in the trade network.
Since neither the device nor the batteries are the waste that can be utilized at home,
follow your national/local regulations for waste recycling and take them to corre-
sponding collection faciliti
es.
USE OF THE DEVICE WITH THE POWER SOURCE
Socket for the power source is arranged on the left side of the device. To use the device
with the power source, connect the power source connector to the device, install the
power source plug into the socket outlet, and press the «START/STOP» button.
When fi nished, turn off the device by pressing the «START/STOP» button, unplug the
power source from the socket outlet and disconnect the power source connector
from the device.
NOTE!
If there is no battery in the device, turning off the power source will result in zeroing
of measurement results stored in the device memory and set date and time. If you do
not want to make the data erased, do not remove the batteries from the device when
using the power source.

SETTING DATE AND TIME

Date and time can be set after installing batteries. Setting the date and time guarantees
the preservation of measurement results with indicated correct date and time. The de-
УСТАНОВКА ДАТЫ И ВРЕМЕНИ
vice can be used without setting the date and time.
Press and hold the SET button until the display fl ashes the value of the year.
4