Table of Contents
Advertisement
Setting the Year
1.
Use the
button to increase and
2.
Setting the Month
button to increase and
Use the
Setting the Day
3.
Use the
button to increase and
4.
Setting the Time
Watch uses a 12-hour time format of day. Use the
ton to confi rm the settings. To stop the setting, press the «START/STOP» button
IMPORTANT! If the date and time are set, then when turned off the device display will show the current time.
CUFF PREPARATION
1. Holding your left arm with the palm facing up place a cuff on a wrist so that the meter display is on the palm side. Should
you fail to put the cuff on your left wrist, place it on the right one
2. Place the cuff on your wrist so that its edge is spaced by 5-10 mm off the palm end. Place the meter on the center of your
wrist
(Fig.4)
.
3. Snugly wrap the cuff on your wrist without leaving any space between the cuff and the wrist. Make sure that the cuff
comfortably fi ts your wrist.
Put the cuff on a bare wrist only. Be careful to prevent your cloth being caught by the cuff .
CORRECT POSITION DURING MEASUREMENT
Measurement in the sitting position
1. Sit down on a chair that you can be comfortably seated with your legs uncrossed, feet fl at
on the fl oor and back supported. Your forearm should also be supported on the table.
2. Lightly raise your left hand with the palm facing up and put your elbow on the table.
3. Bring the cuff to the heart level placing your arm on a case or folded towel (Fig.5).
button to decrease the year value. Press the SET button to confi rm and to pass to the next step
button to decrease the month value. Press the SET button to confi rm and to pass to the next step
button to decrease the day value. Press the SET button to confi rm and to pass to the next step
button to increase and
button to decrease the hour or minute value. Press the SET but-
.
Fig.5
7
.
.
.
5~10mm
Fig.4
Fig.7
Fig.6
Advertisement
Table of Contents
