Setting Date And Time - Nissei WSK-1011 Instruction Manual

Battery Replacement Indicator
Replace all the batteries when the battery replacement indicator is fl ashing on the display during the measurement. If upon the
device turning on the indicator is steadily fl ashing, the measurement will not be possible until all the batteries are replaced. The battery
replacement indicator does not show a discharge degree..
Use alkaline batteries to increase the device operation duration. Ordinary zinc-carbon batteries require more frequent replacement. The enclosed
batteries are meant for testing the sold device, and their operation period can be less than that of batteries acquired in the trade network.
Since neither the device nor the batteries are the waste that can be utilized at home, follow your national/local regulations for waste recycling and
take them to corresponding collection faciliti

SETTING DATE AND TIME

Date and time can be set after installing batteries. Setting the date and time guarantees the preservation of measurement results with indicated
correct date and time. The device can be used without setting the date and time.
Press and hold the SET button until the display fl ashes the value of the year
minute
.
1. Setting the Year
Use the button to increase and
Setting the Month
2.
button to increase and
Use the
3. Setting the Day
Use the button to increase and
Setting the Time
4.
Watch uses a 12-hour time format of day. Use the
ton to confi rm the settings. To stop the setting, press the «START/STOP» button
IMPORTANT! If the date and time are set, then when turned off the device display will show the current time.
es
button to decrease the year value. Press the SET button to confi rm and to pass to the next step
button to decrease the month value. Press the SET button to confi rm and to pass to the next step
button to decrease the day value. Press the SET button to confi rm and to pass to the next step
button to increase and
Date and time are set in the following order: year, month, day, hour and
.
button to decrease the hour or minute value. Press the SET but-
.
6
.
.
.