Mounting The Antenna Unit - Furuno DRS6A-NXT Installation Manual

7. Apply marine sealant to the holes and bolts at the locations indicated with arrows
in the figure below. Also apply marine sealant to the junction between the radiator
and the radiator bracket.
Bolt assembly - side view (detailed)
Spring
washer
Hex. bolt
1.5

Mounting the Antenna Unit

The antenna unit can be mounted using the fixing holes on the outside (200  200 mm)
or inside (140  150 mm) the antenna unit. Normally, use the outside fixing holes.
When 140  150 mm fixing holes already exist on the mounting platform, use the in-
side fixing holes.
1. Set the supplied mounting template to the mounting location, then drill four fixing
holes in the mounting location.
Note: The holes must be parallel with the fore and aft line.
Mounting template
2. Attach four corrosion-proof rubber pads (supplied) to the mounting holes.
Radiator
Flat washer
Marine sealant
Bow Bow
1. INSTALLATION AND WIRING
Apply marine
sealant to these
bolts and holes
Radiator - bottom view
Corrosion-proof rubber pad
8
Apply marine sealant Apply marine sealant
to the junction to the junction
between the radiator between the radiator
and radiator bracket. and radiator bracket.