Propane Conversion - Montigo DelRay Square Series Installation & Maintenance Manual

Propane Conversion
To convert the DelRay from
Natural Gas to Propane,
install the GCA020 / GCA021
conversion kit. The unit must
be disconnected from any
gas supply, disconnected
from any electrical supply and
batteries and removed from
any installation cavity.
For input rating, manifold
pressure and orifice size,
refer to sample rating plate
WARNING
This conversion kit shall be installed by a qualified gas fitter in
accordance with the manufacturer's instructions and all applicable
codes and requirements of the authority having jurisdiction. If the
information in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's
instructions supplied with the kit.
CAUTION
The gas supply shall be shut off prior to disconnecting the electrical
power, before proceeding with the conversion.
XG0230 - 052020
Tools required
1). Torx T20 Screw Driver Bit
2). 1/2" Socket Driver
3). 5/32" Allen Key
4). Needle Nose Pliers or
Small Flat Head Screw
Driver
2). 3/8" wrench
Parts included
1). Propane burner orifice
2). Propane pilot orifice
3). Propane valve control
(with mounting screws)
4). Valve conversion label
5). Conversion plate label
6). Conversion technician
identifying label
1. Shut off gas supply.
2. Remove the 2 screws securing the pilot cover to the media tray.
Figure 13. Removal of pilot cover
3. Burner can now be removed by simply lifting up.
Figure 13.b Removing burner
4. Use 3/8" wrench to loosen off the NG gas orifice, replace with
Propane orifice as included in package.
Figure 13.c Removing the orifice
5. Using a Philips screwdriver, loosen the screw on the primary
air adjuster. Adjust opening to ½" if you have a DRSQ38NI and
using the conversion kit GCA020. Adjust opening to fully open if
you have a DRSQ38NI-2 and using the conversion kit GCA021.
Figure 13.c primary air adjuster
Installation
25