Table of Contents
Advertisement
Propane Conversion (High-Low Burner)
To convert the DelRay from
Natural Gas to Propane, install
the conversion kit listed int
he table below. The unit must
be disconnected from any gas
REV.
DESCRIPTION
supply, disconnected from any
-
.
electrical supply and batteries.
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
Tools required
1). Torx T20 Screw Driver Bit
2). 1/2" Socket Driver
3). 5/32" Allen Key
4). Needle Nose Pliers or
Small Flat Head Screw
Driver
2). 1/4" Socket Driver
NG to LP Conversion Kits
36
Basic
GCA010
Fully Loaded
GCA010
WARNING
This conversion kit shall be installed by a qualified gas fitter in
accordance with the manufacturer's instructions and all applicable
codes and requirements of the authority having jurisdiction. If the
information in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's
instructions supplied with the kit.
CAUTION
The gas supply shall be shut off prior to disconnecting the electrical
power, before proceeding with the conversion.
40
HIGH-LOW
BURNER
Parts included
1). Propane burner orifice
REVISIONS
2). Propane pilot orifice
DATE
CHANGED BY
3). Propane valve control
-
-
(with mounting screws)
4). Valve conversion label
5). Conversion plate label
6). Conversion technician
identifying label
For input rating, manifold
pressure and orifice size,
refer to sample rating plate
48
60
72
GCA019
GCA047
GCA052
GCA019
GCA048
GCA053
Gas conversion steps vary based on what burner the unit is
RIBBON
installed in the fireplace. Check the burner hole pattern to ensure
BURNER
you are using the right instructions.
1. Shut off gas supply.
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
1/32"
Drawn by
2. Remove the 2 screws securing the pilot cover to the media
TWO PLACE DECIMAL
.015"
Revision / Date
THREE PLACE DECIMAL
.005"
tray. Remove 2 screws on burner clamp.
ANGULAR
.5
Revision
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
Finish
OTHERWISE.
3. Burner can now be removed.
4. Use 1/2" Socket Driver to loosen off the NG gas orifice, replace
with Propane orifice as included in package.
5. Adjust the mixer to fully open. If converting from LP to NG,
then slide the sleeve until only a 1/8th gap is exposed.
TIP: Use a 1/8th drill bit to easily measure the
Installation
NAME
DATE
Description
MNR36 Burner Patterns
JL
11/4/2022
DWG. NO.
MNR36 Burner Comparison
MATERIAL
SCALE
1:8
WEIGHT:
Figure 13. Removal of pilot cover
Figure 13.b Loosening the venturi
Figure 13.c Removing the orifice
Figure 13.c Adjusting the orifice
opening needed for natural gas.
SHEET 1 OF 1
XG0226 - 042220
Advertisement
Table of Contents
