Black Reflective Glass - Montigo DelRay Square Series Installation & Maintenance Manual

NOTICE
Panels should be handled with gloves,
oils from the skin will permanently stain glass
Black Reflective Glass
Before beginning any install, make sure that the unit has not been in
operation and that it is at room temperature.
Step 1: Identify correct bracket to use.
Step 2: Remove the two screws on each side where the brackets will go in
Figure 20.b Remove the two screws
Step 3: Put the back glass on first, and temporarily hold it in place using
masking tape. Don't use regular tape as it will leave residue on the glass
Figure 20.b hold it in place using masking tape
32
Step 4: Bend the left side tab on the bracket. Place right side glass in
place, and secure with the bracket using screw
Bend the right side tab on the bracket. Place left side glass in place,
and secure with the bracket using screw.
Figure 20.b Bend the left side tab
Figure 20.b Bend the right side tab
BRACKET
(BENT TAB
SUPPORTS
REAR PANEL)
Figure 20.b Secure with the bracket using screw
Step 5: It is now safe to remove the masking tape.
Installation
REAR PANEL
XG0230 - 052020